Emerson MONITORING OpenComms - Manual (Page 18)

System Configuration
12
destination IP address, and the community name for that host. Up to
20 trap communities can be assigned. For Communities and Trap
Communities, the information can be entered as a “complex” line —
all parameters space-delimited on the command line. Otherwise, the
menu items will prompt for each individual parameter.
Authentication failure traps may be enabled, so that the network
management system can be warned when unauthorized access (i.e.:
incorrect community name) is attempted.
Web Server
The Web Server section will allow the user to disable / enable the
HTTP session for the card. Disabling the Web Server means that web
browsers will not be able to access the devices status graphical page
(GUI).
Telnet
This section allows users to enable or disable the Telnet session.
Change User Name / Password
This section allows users to set or change the default user name and
password.
• Default user name is “Liebert” (case sensitive).
• Default password is “Liebert” (case sensitive).
Firmware Updates Menu
The Firmware Update Menu is intended for Liebert service personnel only. No
user configurable parameters are accessed in this selection. If entered, to escape,
power must be cycled on the card.
Factory Settings Menu
The Factory Settings Menu displays the manufacture date, serial
number and MAC address of the card. These parameters are read-
only. Once all parameters have been entered, press Escape to return
to the Main menu; then press x to save configuration, exit and reboot
to enable the new configuration. All parameters are stored in non-vol-
atile flash memory. Pressing q after Escape will abort all changes.
Neither selection is case-sensitive.
NOTE
SNMP v1 communities are transmitted in plain (unencrypted)
text across the network.