Emerson MONITORING OpenComms - Manual (Page 14)

Installation
8
the Enter key on your keyboard. This will initiate
communications with the card and the following screen should be
displayed.
Figure 4 NIC main menu in HyperTerminal
(You can also cycle power on the OpenComms NIC card. This will
also initiate communications and provide information on current
revision status.)
6. When the message “Initializing Network…” appears, hit the
Enter key on your keyboard. (Additional network information
may appear)
!
CAUTION
Cycling power on either the 7200 or the HiPulse UPS is not
recommended unless the unit is in bypass mode. Consult the
UPS user manual for further instructions.