0 introduction – Magnum Energy MP Extension Box (MPX Series) User Manual

Page 7

2.0 Introduction

Figure 2-1, MPX Series Kit

2.0 Introduction

The MPX Series Extension Kit provides the necessary equipment to mount and connect an additional

Magnum inverter to a MP Series enclosure and panel. The MPX is designed to allow a Magnum in-

verter to fi t seamlessly into the top.

IMPORTANT: If you have not yet installed any of your system (i.e., MP enclosure, fi rst

inverter), refer to the MP Owner’s Manual (PN: 64-0028) for initial setup instructions.

2.1 MPX Series Kit

Carefully remove the MPX from its shipping container and inspect all contents. Verify the below items

are included. Contact your authorized Magnum Energy dealer or Magnum Energy if anything is miss-

ing. Save your proof-of-purchase as a record of your ownership (needed for in-warranty service).

The MPX kit includes (see Figure 2-1):

MPX extension box

Remote cable (300V) - for installing remote

control or router

Inverter hood - for vertically mounting an

inverter

Stacking cable - for series stacking MS4024

inverters or parallel stacking MS-PAE in-

verters

DC disconnect breaker - 250 ADC

See Note* on stacking cables below.

AC breaker - 30 AAC double-pole
(60 AAC single-pole with MPXS-60S)

Labels and mounting hardware (Figure 2-2)

DC positive/negative 2/0 AWG battery

cables (see Table 2-1)

MPX Series Owner’s Manual

MPX AC Wiring Kit - for wiring to the AC

terminals in MP panels (see Table 2-1)

Series Stacking Manual (MPXS-60S models

only)

Note* - The supplied parallel stacking cables must be used when installing the router. They are

like standard CAT 5 cables, but are rated for 300V to allow their use with the MS-PAE inverters and

to meet electrical safety code requirements.