Tcp/ip address inverter type com1 config – Yaskawa SmartTrac AC1 User Manual

Page 35

SMART TRAC AC1

Technical Manual TM 3554-000 Smart Trac AC1 Installation

••

4-15

IP Address

Subnet Mask

Gateway Address

DNS Server Addr

TCP/IP Config

Inverter Type

Serial Download?

Firmware Version

Start System?

ENTER

COM1 Config

ENTER

Starting OS

Load from COM1..

Erase FLASH...

Program FLASH...

MagneTek

Smart Trac

Starting OS

Baud Rate

If 2 sec
timeout

occurs

Operating System

Monitor

Boot Code

Flash Access

ENTER

Erase this?

User Program

2ms Torq Update

5ms Torq Update

ENTER

Figure 5.

The Smart Trac AC1 Boot Process.

Refer to "Addresses and subnet mask" for information on setting the TCP/IP
address through the Boot Menu.

This function changes the Torque Update parameter from 2 milliseconds to 5
milliseconds. Do not change this function without the approval of an application
engineer.

Using this function enables you to change the baud rate of the RS-232
communications port located on display panel. Normally, this port is only used
to download operating system, monitor and boot programs. It should not
normally be changed.

TCP/IP Address

Inverter Type

COM1 Config