Yaskawa SmartTrac AC1 - Manual (Page 11)

SMART TRAC AC1
Technical Manual TM 3554-000 Important Safety and Warranty Information
••
1-3
WARNING WARNING
Verify that the rated voltage of the Smart Trac AC1 matches the
voltage of the incoming power.
Always ground the Smart Trac AC1 using ground terminal G. See the
detailed instructions provided in the Smart Trac Technical Manual.
Wiring must be performed only by qualified personnel.
Do not perform a "HIPOT" or withstand voltage test on any part of
the Smart Trac AC1. The AC1 uses semi-conductors and is vulnerable
to high voltage.
Never connect the main circuit output terminals T1, T2 and T3 to the
AC main circuit power supply.
All parameters have been factory set to values commonly used. Do
not change their settings without good reason.
Failure to comply with this warning may result in damage to the
Smart Trac AC1 and connected equipment along with personal injury
and/or death.
WARNING WARNING -- ESD ESD
The Control Printed Circuit Board (PCB) employs CMOS Integrated
Circuits that are easily damaged by static electricity. Use proper
Electrostatic Discharge (ESD) procedures when handling the Control
PCB. Failure to comply may result in damage to equipment and/or
personal injury.
CAUTION CAUTION
All parameters have been factory set to values commonly used. Do not
change their settings without a full understanding of their impact on
Smart Trac AC1 and machine operation. Failure to comply may result
in damage to equipment and/or personal injury.