Yaskawa SmartTrac AC1 - Manual (Page 17)

SMART TRAC AC1
Technical Manual TM 3554-000 Assembling a Smart Trac AC1
••
3-3
a. Locate two block pin positions on the female PC/104 connector.
Using a pin or other sharp object, carefully remove two black plugs
from the two blocked pin positions.
b. Orient the Smart Trac PG card so that the PC/104 connector and
the J2 connector (on the solder side of the card) align with the
PC/104 connector on the Smart Trac CPU card and the 4CN
connector on the Inverter Control card. The standoff hole above J6
must slip over the plastic standoff. Be careful to align the PC/104
connector pins with the receptacle on the Smart Trac CPU card so
the pins don't bend when the card is pushed into place.
c. Gently but firmly push the Smart Trac PG card onto the Smart
Trac CPU card. Make sure connecting pins are in alignment and J2
mates with 4CN before pushing the two boards tightly together.
Secure the card using four (4) metal standoffs and one (1) plastic
standoff. Tighten metal standoffs with fingers (torque to about 10
lb-ft).
13. Position the Adapter Ring over the drive chassis, aligning two tabs on
the right side of the ring with slots in the chassis.
14. Secure the Adapter Ring to the chassis using two or four Phillips head
screws, depending on drive case size.
15. Connect the 9-pin RS-232 cable at connector J5 on the Smart Trac CPU
card.
16. If your unit includes a Smart Trac PG card, connect the ground strap
from J11 on the Smart Trac PG card, to the left inside and top inside of
the Adapter Ring.
17. Connect the 12-pin wiring harness from the Digital Operator to
connector J4 on the Smart Trac PS card.
18. Install other option cards per instructions included with each card. See
"Option Cards" below for general information.
19. Close the cover and tighten the screws or single captive screw to secure
the cover.
20. Your Smart Trac AC1 should not be assembled and ready for
connection to a 110V power supply.