Yaskawa YASNAC PC NC Maintenance Manual - Manual (Page 136)

The VS-626M5 PC NC Maintenance Manual
4-115
Note: Some of the connectors attached with control PC board and option cards are of the same type.
Therefore, care must be used to mount the cards to the correct connectors, each of which is identi-
fied by a device symbol. If an incorrect connection is made, damage to the inverter may occur.
9CN Load shaft
encoder signal
output 10214–
52A2JL ·10114–
3000VE
·10314–
52A0–008
(case) 0.2 mm 2 Sumitomo 3M
Ltd.
Magnetic
Sensor
Method
Orientation
Card
(VS-626M5) 10CN Control signals 10214–
52A2JL
·10114–
3000VE
·10314–
52A0–008
(case)
0.2 mm
2 Sumitomo 3M
Ltd.
Control PC
Board
(VS-
656MR5) 5CN Control signal
connector with
other drive unit 8831E–034–
170LD 8822E–
034–171D Use a special
cable. KEL Corp.
1CN Communica-
tion cable
connector (for
factory test
prior to ship-
ment) 10214–
52A2JL ·10114–
3000VE
·10314–
52A0–008
(case) „Ÿ Sumitomo 3M
Ltd.
Table 4.26: Control Signal Connectors (Continued)
Connector
Number
Function
Connector Type
Connector
Pin
Numbers
Applicable
Maximum
Wire Size
Connector
Manufacturer
Inverter Side
Wiring
Side
14
8
7
1
14
8
7
1
34
32
4
2
33
31
3
1
14
8
7
1