Yaskawa GPD 515/G5 to G7 - Manual (Page 36)

Product Transition Guide
GPD515/G5 to G7
GPD515/G5 Parameters G7 Parameters
Parameter
No.
Name
(DigitalOperator
Display)
Setting or Selection
Parameter
No.
Name
(Digital Operator Display)
Remarks on
Setting or Selection
O1-05 Parameter No.
Display Selection
Address Display 0:Parameter Number
1:Memobus Address o1-05 LCD Brightness
Adjustment Modified function:
Sets the contrast of the digital
operator LCD. A set ting of
“1” is the lightest contrast and
a setting of “5” is the darkest
contrast.
— — — o2-10 Cumulative CoolingFan
Operation Time Setting New parameter
— — — o2-12 Fault Trace/Fault
History Clear Function New parameter
0: Disabled no effect.
1: Enabled - resets U2 and U3
monitors, and returns o2-12 to
zero.
— — —
o2-14
kWh User Monitor
Initialization New parameter
0: Disabled no change.
1: Enabled - Resets U1-29 to
zero and returns o2-14 to zero.
— — — o3-01 Copy Function
Selection New parameter
0: COPY SELECT no
function
1: INV -> OP READ - All
parameters are copied from
the Drive to the digital
operator.
2: OP -> INV WRITE - All
parameters are copied from
the digital operator to the
Drive.
3: OP<-->INV VERIFY -
Parameter settings in the Drive
are compared to those in the
digital operator.
NOTE: When using the copy
function, the Drive model
number o2-04, software
number U1-14, and control
method A1-02 must match or
an error will occur.
— — — o3-02 Copy Allowed
Selection
Read Allowable New parameter
0: Disabled - No digital
operator copy functions are
allowed.
1: Enabled - Copying allowed
PL.G7.02.TransitionGuide 4/21/04
Page 36 of 38
Yaskawa Electric America, Inc