Yaskawa GPD 515/G5 to G7 User Manual
Page 27

Product Transition Guide
Appendix 2- Parameter Differences
____________________________
PL.G7.02.TransitionGuide 4/21/04
Page 27 of 38
Yaskawa Electric America, Inc
GPD515/G5 Parameters
G7 Parameters
Parameter
No.
Name
(DigitalOperator Display)
Setting or Selection
Parameter
No.
Name
(Digital Operator Display)
Remarks on
Setting or Selection
—
— —
F5-03
DO-08 Channel 3 Output
Selection
New Parameter
—
— —
F5-04
DO-08 Channel 4 Output
Selection
New Parameter
—
— —
F5-05
DO-08 Channel 5 Output
Selection
New Parameter
—
— —
F5-06
DO-08 Channel 6 Output
Selection
New Parameter
—
— —
F5-07
DO-08 Channel 7 Output
Selection
New Parameter
—
— —
F5-08
DO-08 Channel 8 Output
Selection
New Parameter
—
— —
F5-09
DO-08 Output Mode
Selection
New Parameter
0:8-channel individual outputs.
1:Binary code output.
2:Output according to
F5-01 to F5-08 settings.
F9-02 Option External Fault
Detection Selection
0:Always Detected
1:Only During Run
F6-02
Option External Fault
Detection Selection
Changed Parameter No.
F9-03 Option External Fault
Detection Operation
Selection
0: Ramp to Stop
1: Coast to Stop
2: Fast - Stop
3: Alarm Only
F6-03
Option External Fault
Detection Operation
Selection
Changed Parameter No.
F9-04 Trace Sampling Time
—
F6-04
Trace Sampling from
Communications Option
Board
Changed Parameter No.
TorqueReference/
F9-05
Torque Limit Selection
through DP-RAM
communication
0: Disabled
1: Enabled
F6-06
Torque Reference/Torque
Limit Selection through
DP- RAM communication
Changed Parameter No.
F9-06 DP-RAM Communication
Error Detection Operation
Selection
0:Ramp to Stop
1:Coast to Stop
2:Fast - Stop
3:Alarm Only
F6-01
DP-RAM Communication
Error Detection Operation
Selection
Changed Parameter No.