Yaskawa DriveWizard Plus - Manual (Page 26)

26
9) Select the appropriate communication port and click “Connect”.
When Using Ethernet
Select “Ethernet” for the communication port.
Drive Connect Window
When Using Ethernet (LP)
Select “Ethernet (LP)” for the communication port.
Drive Connect Window
When using Ethernet (LP), verify the IP address for possible controller devices as described below.
1) Click “Search”.
The controller names, IP addresses, ports, and module names should appear in the window.
2) Make sure that the IP address of the communication port that has been selected matches
the information listed in the search results window, then click “Connect”.
NOTE: The controller search window appears only when Ethernet (LP) has been selected.