Yaskawa E7 Drive User Manual - Manual (Page 60)

Digital Operator 3 - 12
Quick Setting Menu (-QUICK-)
This menu is used to set/read the most commonly used parameters in the Drive. Follow the key operations below (Fig 3.6) to
access the Quick Setting Menu:
Fig 3.6 Quick Setting Parameter Access Procedure
Use and keys to scroll through the “Quick Setting” parameter list.
* This parameter’s menu location is Quick Setting when b5-01=1, and Programming when b5-01=0.
Table 3.11 Quick Setting Parameter List
Parameter
Number
Parameter Name
b1-01 Frequency Reference Selection
b1-02 Run command Selection
b1-03 Stopping Method Selection
b5-01 PI Mode Selection
b5-02* Proportional Gain Setting
b5-03* Integral Time Setting
b5-31* PI Unit Selection
C1-01 Acceleration Time 1
C1-02 Deceleration Time 1
d2-01 Frequency Reference Upper Limit
d2-02 Frequency Reference Lower Limit
E1-01 Input Voltage Setting
E2-01 Motor Rated Current
H3-08* Terminal A2 Signal Level Selection
H3-09* Auxiliary Terminal Function Selection
H3-13* Master/Frequency Reference Terminal Selection
-QUICK-
** Main Menu **
- - - - - - - - - - - - - -
Quick Setting
-QUICK-
Reference Source
- - - - - - - - - - - - - - - - - - - -
B1-01= 1 *1*
Terminals
“1” x2
TM_E7_01_07182008.book Page 12 Wednesday, July 23, 2008 2:35 PM