Yaskawa SI-ET3 - Manual (Page 9)

4 Option Components
YASKAWA ELECTRIC SIEP C730600 62B 1000-Series Option SI-ET3 Technical Manual 9
‹ Option LED Display
The MECHATROLINK-III Option has four LEDs that indicate the option card or communication status.
„ Checking LED Operation
Table 4 Option LED States
Name Display Operating Status Remarks
R/E
Lit in
green
Power supply on
• SI-ET3 has been successfully powered up
• An internal, self-diagnostic check completed in the SI-ET3
Lit in red Error
• Error/alarm occured
• Command error occurred (parameter error, phase error, combination error)
Flashing in
red
SI-ET3 error Error found during SI-ET3’s self-diagnostic check
Unlit Power supply off
• The drive has no power
• SI-ET3 is not properly connected to the drive, or SI-ET3 has no power
• An internal, self-diagnostic error occurred in the SI-ET3
CON
Lit in
green
Connection established Established connection
Unlit Connection unestablished Connection with master device is not established
LK1
Lit in
green
Connector CN1 connected Connector CN1 is connected to other stations
Unlit
Connector CN1
disconnected Connector CN1 is not connected to other stations (cable not connected, cable
disconnected, other stations not powered up)
LK2
Lit in
green
Connector CN2 connected Connector CN2 is connected to other stations
Unlit
Connector CN2
disconnected Connector CN2 is not connected to other stations (cable not connected, cable
disconnected, other stations not powered up)