Yaskawa SI-ET3 - Manual (Page 16)

5 Installation Procedure
16 YASKAWA ELECTRIC SIEP C730600 62B 1000-Series Option SI-ET3 Technical Manual
Table 5 MECHATROLINK-III Communication Cable
7. Replace and secure the front covers of the drive (C, F) and replace the digital operator (D).
Figure 9
Figure 10 Replace the Front Covers and Digital Operator
Note: Take proper precautions when wiring the option so that the front covers will easily fit back onto the drive. Make sure no cables
are pinched between the front covers and the drive when replacing the covers.
8. Set drive parameters in Table 6 for proper option performance.
Connection Type Cable Specification Length (L) Model
MECHATROLINK-III
connection without
ferrite core
0.2 m (7.9 in.) JEPMC-W6012-A2-E
0.5 m (19.7 in.) JEPMC-W6012-A5-E
1 m (39.4 in.) JEPMC-W6012-01-E
2 m (78.7 in.) JEPMC-W6012-02-E
3 m (118.1 in.) JEPMC-W6012-03-E
4 m (157.5 in.) JEPMC-W6012-04-E
5 m (196.9 in.) JEPMC-W6012-05-E
10 m (393.7 in.) JEPMC-W6012-10-E
20 m (787.4 in.) JEPMC-W6012-20-E
30 m (1181.1 in.) JEPMC-W6012-30-E
50 m (1968.5 in.) JEPMC-W6012-50-E
MECHATROLINK-III
connection with
ferrite core
10 m (393.7 in.) JEPMC-W6013-10-E
20 m (787.4 in.) JEPMC-W6013-20-E
30 m (1181.1 in.) JEPMC-W6013-30-E
50 m (1968.5 in.) JEPMC-W6013-50-E
75 m (2952.8 in.) JEPMC-W6013-75-E
100 m (3937.0 in.) JEPMC-W6013-100-E
MECHATROLINK-III
connection with loose
wires at one end
0.5 m (19.7 in.) JEPMC-W6014-A5-E
1 m (39.4 in.) JEPMC-W6014-01-E
3 m (118.1 in.) JEPMC-W6014-03-E
5 m (196.9 in.) JEPMC-W6014-05-E
10 m (393.7 in.) JEPMC-W6014-10-E
30 m (1181.1 in.) JEPMC-W6014-30-E
50 m (1968.5 in.) JEPMC-W6014-50-E
L
L
Wind the cable one turn
around the ferrite core.
L
F
C
D
A1000