SMA Communit-10 User Manual
Page 19
SMA Solar Technology AG
5 Mounting
Installation Manual
Communit-IA-A1-en-22
19
10. Screw the Communit into place at the four anchoring points on the
base extension. Use the square washers.
11. Mount the lower kick plate on the first base extension and turn the
locking latches inwards.
12. Mount the upper kick plate under the Communit on the second
base extension and attach using two countersunk screws.
13. Ensure that all connectors inside the Communit are firmly positioned.
5.4 Determining the Optimum Mounting Location for the Antenna
If you have ordered the Communit with a UMTS router, the antenna included in the delivery must be mounted.
Procedure:
1. Connect the antenna cable plug to the router (see Section 6.4 "Connecting the Cables to the Network Switch and
2. Select the mounting location of the antenna. Take the maximum cable length of 5 m into account.
3. Check whether the signal strength at the selected mounting location is sufficient:
• Log into the router (see Section 7.2 "Configuring the Router", page 33).
• Read off the signal strength in the field Signal strength.
The signal strength is sufficient if the field Signal strength is showing either Good or Very good.
Lightning protection
Observe the local lightning protection regulations when mounting the antenna.
&$87,21
Radiation hazard due to high power density of the antenna
Electromagnetic radiation from the antenna can be damaging to health.
• Maintain a personal safety clearance of at least 4 cm from the antenna in operation.