SMA Replacement of SMA Devices in Systems with SMA - Manual (Page 29)

SMA Solar Technology AG 12 Appendix
Installation Manual Geraeteaustausch-IA-en-20 29
7. Remove the power cable from the defective Battery Pack. Turn the plug lock to the left until the plug releases and
then pull the plug out of the pin connector.
8. If the protective caps of the pin connectors for the data cable and the power cable are available, use them to cover
the corresponding pin connectors of the defective Battery Pack.
9. Insert the data cable and power cable into the bracket on the left-hand side of the inverter.
10. Remove the defective Battery Pack in an upright position from the wall mounting bracket.
Mounting the New Battery Pack and Connecting It to the Inverter
1. Remove the new Battery Pack from the packaging and put the packaging aside. Be careful when handling the
packaging as you will need it later for packing the defective Battery Pack.
2. Hang the new Battery Pack to the left of the inverter in the wall mounting bracket. The right-hand side of the
Battery Pack must be flush with the hook-in position marked on the wall mounting bracket.
3. Remove the protective caps from the pin connectors for the data cable and power cable and retain them for possible
decommissioning.
4. If the protective caps of the defective Battery Pack are no longer available, place the protective caps of the new
Battery Pack onto the pin connectors of the defective Battery Pack.
5. Release the data cable and the power cable from the bracket on the inverter.
6. Insert the power cable plug in the pin connector for the power cable. Insert the plug into the pin connector and turn
the lock to the right until the plug snaps into place.
7. Ensure that the plug is securely in place.
8. Connect the data cable for communication between the inverter and the Battery Pack to the D-sub plug of the
Battery Pack.
9. The plug snaps audibly into place.
11. Position the protective cover over the Battery Pack. The brackets on the right-hand side of the protective cover must
engage with the guides on the left of the inverter enclosure. Then press the left side of the protective cover down onto
the Battery Pack until it snaps into place.
Packing the Defective Battery Pack and Organizing Its Return
1. Place the supplied foil bag in the packaging in which the new Battery Pack was delivered. The open side of the foil
bag must face upwards.
2. Place the defective Battery Pack in the foil bag.
3. Place the moisture absorber next to the defective Battery Pack in the foil bag.
4. Close the foil bag.
5. Seal the packaging with suitable adhesive tape.
6. Organize the return of the package. Contact the SMA Service Line.
10. &$87,21
Danger of crushing if the Battery Pack is jolted
• Grip the Battery Pack by the handles and carefully push it to the right as far as it will go.
'$1*(5
Danger to life due to incorrect packaging and transport
The Battery Pack is considered to be dangerous goods. Special regulations must be complied with
regarding packaging and transport.
• Packaging and transport of the Battery Pack may only be carried out by persons who have
been trained in accordance with Section 1.3 ADR and whose training has been documented.