SMA MULTICLUSTER BOX 12 - Manual (Page 39)

SMA Solar Technology AG 11 Decommissioning
Operating Manual MC-BOX-12-3-20-BE-en-10 39
11 Decommissioning
11.1 Disassembling the Multicluster Box
2. Remove all fastening screws from the kick plates at the front and rear. Retain screws for later use. These screws will
be needed later to reattach the kick plates.
3. Disassemble protective cover and base plates.
4. Remove all cables from the Multicluster Box.
5. Release and remove the fastening screws of the Multicluster Box.
6. Mount the protective cover and base plates.
7. Close the doors of the Multicluster Box.
9. Remount the kick plates on the Multicluster Box(see Section 6.11, page 26).
11.2 Disposing of the Multicluster Box
• Dispose of the Multicluster Box in accordance with the locally applicable disposal regulations for electronic waste.
1. '$1*(5
High voltages are present in the Multicluster Box and the multicluster system. Touching live components results in
death or serious injury due to electric shock.
Disconnect the Multicluster Box and multicluster system (see Section 8, page 28).
8. :$51,1*
Danger of crushing if the raised or suspended Multicluster Box topples or falls
The Multicluster Box can topple or fall if it is lifted and transported carelessly or hastily. This can result in death or
serious injury.
• Always transport the Multicluster Box as close to the ground as possible.
• Use means of transportation which are adequate for the weight of the Multicluster Box of 200 kg.
• Transport the Multicluster Box in an upright position. Keep a safe distance from the Multicluster Box at all times
during transport.
• Take the center of gravity of the Multicluster Box into account. The center of gravity of the Multicluster Box is
located approximately in the center of the cabinet and is marked on the package with the center of gravity
symbol.