SMA STP 15000TL Service Manual - Manual (Page 41)

7. Insert the lower enclosure lid from above and
fold it down. The screws must protrude from the
lower enclosure lid.
8. Tighten all six screws with an Allen key (AF 3) in
the order 1 to 6 (torque: 2.0 Nm ± 0.3 Nm). By
tightening the screws in the prescribed order,
you avoid warping the enclosure lid, which
would keep it from sealing correctly.
Useful hint: If the screws fall out of the lower
enclosure lid, insert the long screw into the lower
middle hole and the five short screws into the
other holes.
9. Securely plug in the ESS. The ESS must be aligned parallel to and flush with the enclosure.
10.
Risk of burns due to hot enclosure parts
• Wait 30 minutes for the enclosure to cool down.
11. Using an Allen key (AF 4), unscrew the two M5x10 cylindrical screws by which the inverter is
fastened to the rear panel.
12. Raise the inverter to remove it from the rear panel.
13. If the inverter is to be stored or shipped in packaging, pack the inverter and, if applicable, the
ESS. Use the original packaging or packaging that is suitable for the weight and dimensions of
the inverter.
14. Dispose of the inverter in accordance with the locally applicable disposal regulations for
electronic waste.
13 Decommissioning the Inverter SMA Solar Technology AG
Service Manual 41 STP15-17TL-10-SG-en-10