SMA 20000TL Installation - Manual (Page 23)

SMA Solar Technology AG 5 Electrical Connection
Installation Manual PCONTROLMOD-IA-en-15 23
5.7 Using the Ripple Control Receiver Signal for Additional
Inverters
Additionally required material (not included in the scope of delivery):
☐ One connection cable for each additional inverter (see Section 5.2 "Cable Requirements",
page 14)
Requirements:
☐ The module must be installed in all inverters (see Section 5.3 "Installation of the Module",
page 15).
☐ The ripple control receiver must be connected to one of the modules (see Section 5.6
"Connecting the Ripple Control Receiver", page 19).
☐ The required enclosure openings on all inverters must be prepared (see Section 5.4 "Preparing
the Enclosure Opening on the Inverter", page 18).
☐ Both ends of the connection cable must be prepared for connection to a multi-pole plug
(see Section 5.5 "Preparing the Connection Cables for Connection to Multi-Pole Plugs",
page 19).
Figure 6: Cabling for transmission of the signal from the ripple control receiver (example)
Possible to connect a maximum of five modules in parallel
You can use the signal from one ripple control receiver for a maximum of five inverters with
modules.