HEIDENHAIN TNC 620 (340 56x-01) - Manual (Page 505)

HEIDENHAIN TNC 620 505
13.1 Mac
h
ine-Specific User P
a
ra
met
e
rs
Settings for the NC editor
Generate backup files
TRUE: Generate backup file after editing NC programs
FALSE: Do not generate backup file after editing NC programs
Behavior of the cursor after deletion of lines
TRUE: Cursor is placed on the preceding line after deletion (iTNC behavior)
FALSE: Cursor is placed on the following line after deletion
Behavior of the cursor on the first or last line
TRUE: Cursor jumps from end to beginning of program
FALSE: Cursor does not jump from end to beginning of program
Line break with multiline blocks
ALL: Always display all lines
ACT: Only display the lines of the active block completely
NO: Only display all lines when block is edited
Activate help
TRUE: Always display help graphics during input
FALSE: Only display help graphics if HELP was activated by pressing the key
Behavior of the soft-key row after a cycle entry
TRUE: The cycle soft-key row remains active after a cycle definition
FALSE: The cycle soft-key row is hidden after a cycle definition
Safety check when deleting blocks
TRUE: Display confirmation question when deleting an NC block
FALSE: Do not display confirmation question when deleting an NC block
Program length for which the geometry is to be checked
100 to 9999: Program length for which the geometry is to be checked
Paths for the end user
List of drives and/or directories
Drives or directories entered here are shown in the TNC’s file manager
Universal Time (Greenwich Mean Time)
Time difference to universal time [h]
-12 to 13: Time difference in hours relative to Greenwich Mean Time
Parameter Settings