HEIDENHAIN TNC 620 (340 56x-01) - Manual (Page 327)

HEIDENHAIN TNC 620 327
8.5 SL Cy
cles
Example: Cylinder surface with Cycle 27
Notes:
„ Cylinder centered on rotary table
„ Datum at center of rotary table
„ Description of the midpoint path in the
contour subprogram
0 BEGIN PGM C28 MM
1 TOOL CALL 1 Y S2000 Call tool, tool axis is Y
2 L Y+250 RO FMAX Retract the tool
3 L X R0 FMAX Position tool on rotary table center
4 CYCL DEF 14.0 CONTOUR GEOMETRY Define contour subprogram
5 CYCL DEF 14 .1 CONTOUR LABEL 1
6 CYCL DEF 27 CYLINDER SURFACE Define machining parameters
Q1=-7 ;MILLING DEPTH
Q3=+0 ;ALLOWANCE FOR SIDE
Q6=2 ;SET-UP CLEARANCE
Q10=4 ;PLUNGING DEPTH
Q11=100 ;FEED RATE FOR PLUNGING
Q12=250 ;FEED RATE FOR MILLING
Q16=25 ;RADIUS
Q17=1 ;TYPE OF DIMENSION
7 L C+0 R0 FMAX M3 Pre-position rotary table
8 CYCL CALL Cycle call
9 L Y+250 R0 FMAX M2 Retract in the tool axis, end program
10 LBL 1 Contour subprogram, description of the midpoint path
11 L X+40 Y+0 RR Data for the rotary axis are entered in mm (Q17=1)
X
Y
157
52.5
40
35
60
70