HEIDENHAIN TNC 620 (340 56x-01) - Manual (Page 100)

100
4.4 Cr
eating and W
riting Pr
ogr
a
ms
Possible feed rate input
Actual position capture
The TNC enables you to transfer the current tool position into the
program, for example during
„ Positioning-block programming and
„ Cycle programming
To transfer the correct position values, proceed as follows:
 Place the input box at the position in the block where you want to
insert a position value.
 Select the actual-position-capture function. In the soft-
key row the TNC displays the axes whose positions
can be transferred.
 Select the axis. The TNC writes the current position of
the selected axis into the active input box.
Functions for setting the feed rate Soft key
Rapid traverse
Traverse feed rate automatically calculated in
TOOL CALL
Move at the programmed feed rate (unit of
measure is mm/min)
Functions for conversational guidance Key
Ignore the dialog question
End the dialog immediately
Abort the dialog and erase the block
In the working plane the TNC always captures the
coordinates of the tool center, even though tool radius
compensation is active.
In the tool axis the TNC always captures the coordinates
of the tool tip and thus always takes the active tool length
compensation into account.
The actual-position-capture function is not allowed if the
tilted working plane function is active.