HEIDENHAIN iTNC 530 (340 49x-06) Pilot - Manual (Page 76)

76
Definin
g
Mac
hin
ing Oper
ation
s
Additional parameters on the drilling parameters detail form:
U Chip breaking depth : Depth at which chip breaking is to occur
U Angle of spindle : Angle to which smarT.NC positions the tool before
thread cutting: This permits regrooving of the thread, if needed
U S factor for retraction Q403: Factor by which the TNC increases
the spindle speed — and therefore also the retraction feed rate —
when retracting from the hole
Globally effective parameters on the global data detail form:
U Setup clearance
U 2nd setup clearance
U Retraction value for chip breaking
U Feed rate for traversing between machining positions