HEIDENHAIN iTNC 530 (340 49x-06) Pilot - Manual (Page 73)

73
Definin
g
Mac
hin
ing Oper
ation
s
Unit 206 Tapping with a Floating Tap Holder
Parameters on the overview form:
U T : Tool number or name (switchable via soft key)
U S : Spindle speed [rpm] or cutting speed [m/min or ipm]
U F : Drilling feed rate: Calculate from S multiplied by thread pitch p
U Depth of thread : Depth of the thread
U Machining positions (see “Defining Machining Positions” on page 149)
Additional parameters on the tool detail form:
U DL : Delta length for tool T
U M function : Any miscellaneous function M
U Spindle : Direction of spindle rotation. As a default, smarT.NC sets M3
U Tool preselect : If needed, this is the number of the next tool for faster
tool change (machine-dependent)