HEIDENHAIN iTNC 530 (340 49x-06) Pilot - Manual (Page 184)

184
Pr
ocessing
DXF
Files (Sof
tw
ar
e
Option)
Opening a DXF file
The DXF converter can be started in different ways:
„ From the file management if you want to extract several contour or
position files consecutively
„ From the form during the machining definition of units 125 (contour
train), 122 (contour pocket) and 130 (contour pocket on point pattern) if
you are supposed to enter the names of the contours to be machined
„ While defining the machining, if you enter the machining positions via
point files
The TNC automatically saves the datum defined by you and
the current zoom condition upon exiting the DXF converter.
If you want to open the same DXF file again, the TNC loads
this information (valid for the previously selected file).