HEIDENHAIN iTNC 530 (340 49x-06) Pilot - Manual (Page 117)

117
Definin
g
Mac
hin
ing Oper
ation
s
Additional parameters on the tool detail form:
U DL : Delta length for tool T
U DR : Delta radius for tool T
U DR2 : Delta radius 2 (corner radius) for tool T
U M function : Any miscellaneous function M
U Spindle : Direction of spindle rotation. As a default, smarT.NC sets M3
U Tool preselect : If needed, this is the number of the next tool for faster
tool change (machine-dependent)
Additional parameters on the milling parameters detail form:
U Infeed for finishing : Infeed for finishing on the side. If nothing is
entered, finishing is performed in one infeed
U F rate for finishing : Feed rate for finishing [mm/min], FU [mm/rev]
or FZ [mm/tooth]
Globally effective parameters on the global data detail form:
U Setup clearance
U 2nd setup clearance
U Climb milling, or
U Up-cut milling
U Plunge in a helical motion, or
U Plunge in a reciprocating motion, or
U Plunge vertically