HEIDENHAIN iTNC 530 (340 49x-06) Pilot - Manual (Page 123)

123
Definin
g
Mac
hin
ing Oper
ation
s
Unit 232 Face Milling
Parameters on the overview form:
U T : Tool number or name (switchable via soft key)
U S : Spindle speed [rpm] or cutting speed [m/min or ipm]
U F : Feed rate for milling [mm/min] or FU [mm/rev] or FZ [mm/tooth]
U Milling plan : Selection of the milling plan
U Starting point in 1st axis : Starting point in the reference axis
U Starting point in 2nd axis : Starting point in the minor axis
U Starting point in 3rd axis : Starting point in the tool axis
U End point in 3rd axis : End point in the tool axis
U Allowance in depth : Finishing allowance for the depth
U 1st side length : Length of the surface to be milled in the reference
axis, referenced to the starting point
U 2nd side length : Length of the surface to be milled in the minor axis,
referenced to the starting point
U Maximum infeed : Maximum infeed per cut
U Clearance to side : Lateral distance by which the tool moves beyond
the surface