HEIDENHAIN TNC 320 (77185x-01) ISO programming - Manual (Page 536)

Tables and overviews
17.5 Functions of the TNC 320 and the iTNC 530 compared
17
536
TNC 320 | User's Manual for DIN/ISO Programming | 3/2014
Function TNC 320 iTNC 530
Find function:
List of words recently searched
for
Not available Available
Show elements of active block Not available Available
Show list of all available NC
blocks
Not available Available
Starting the find function with
the up/down arrow keys when
highlight is on a block
Works with max. 9999 blocks, can
be set via config datum
No limitation regarding program
length
Programming graphics:
True-to-scale display of grid Available Not available
Editing contour subprograms in
SLII cycles with
AUTO DRAW
ON
If error messages occur, the
cursor is on the
CYCL CALL
block in the main program
If error messages occur,
the cursor is on the error-
causing block in the contour
subprogram
Moving the zoom window Repeat function not available Repeat function available
Programming minor axes:
Syntax FUNCTION
PARAXCOMP: Define the
behavior of the display and the
paths of traverse
Available Not available
Syntax FUNCTION
PARAXMODE: Define the
assignment of the parallel axes
to be traversed
Available Not available
Programming OEM cycles
Access to table data Via SQL commands
and via FN17/FN18 or
TABREAD-TABWRITE functions
Via FN17/FN18 or
TABREAD-TABWRITE functions
Access to machine parameters With the CFGREAD function Via FN18 functions
Creating interactive cycles
with
CYCLE QUERY, e.g.
touch-probe cycles in Manual
Operation mode
Available Not available
Comparison: Differences in Test Run, functionality
Function TNC 320 iTNC 530
Test Run up to block N Function not available Function available
Calculation of machining time Each time the simulation is
repeated by pressing the START
soft key, the machining time is
totaled
Each time the simulation is
repeated by pressing the START
soft key, time calculation starts at
0