HEIDENHAIN TNC 320 (77185x-01) ISO programming User Manual
Page 33
TNC 320 | User's Manual for DIN/ISO Programming | 3/2014
33
12 Programming: Multiple Axis Machining.................................................................................... 347
12.1 Functions for multiple axis machining............................................................................................. 348
12.2 The PLANE Function: Tilting the Working Plane (Software Option 1)...........................................349
Introduction........................................................................................................................................... 349
Defining the PLANE function................................................................................................................351
Position display......................................................................................................................................351
Resetting the PLANE function..............................................................................................................352
Defining the working plane with the spatial angle: PLANE SPATIAL....................................................353
Defining the working plane with the projection angle: PLANE PROJECTED....................................... 355
Defining the working plane with the Euler angle: PLANE EULER........................................................356
Defining the working plane with two vectors: PLANE VECTOR.......................................................... 358
Defining the working plane via three points: PLANE POINTS..............................................................360
Defining the working plane via a single incremental spatial angle: PLANE SPATIAL............................362
Tilting the working plane through axis angle: PLANE AXIAL (FCL 3 function)......................................363
Specifying the positioning behavior of the PLANE function.................................................................365
12.3 Miscellaneous functions for rotary axes.......................................................................................... 370
Feed rate in mm/min on rotary axes A, B, C: M116 (software option 1).............................................. 370
Shortest-path traverse of rotary axes: M126........................................................................................371
Reducing display of a rotary axis to a value less than 360°: M94........................................................372
Selecting tilting axes: M138................................................................................................................. 373