beautypg.com

5 using 3-d touch probes, Overview, Using 3-d touch probes – HEIDENHAIN TNC 320 (77185x-01) ISO programming User Manual

Page 399: Using 3-d touch probes 13.5

background image

Using 3-D touch probes

13.5

13

TNC 320 | User's Manual for DIN/ISO Programming | 3/2014

399

13.5

Using 3-D touch probes

Overview

The following touch probe cycles are available in the Manual

Operation mode:

HEIDENHAIN only gives warranty for the function of

the probing cycles if HEIDENHAIN touch probes are

used.

The TNC must be specially prepared by the machine

tool builder for the use of a 3-D touch probe. Refer to

your machine manual.

Function

Soft key

Page

Calibrating the effective length

407

Calibrating the effective radius

408

Measuring a basic rotation using a

line

412

Setting a datum in any axis

414

Setting a corner as datum

415

Setting a circle center as datum

417

Setting the centerline as datum

419

Touch probe system data

management

See

User’s

Manual

for Cycles

For more information about the touch probe table,

refer to the User’s Manual for Cycle Programming.