Fundamentals tnc model, software and features – HEIDENHAIN TNC 320 (77185x-01) ISO programming User Manual
Page 12

Fundamentals
TNC model, software and features
12
TNC 320 | User's Manual for DIN/ISO Programming | 3/2014
New functions 77185x-01
New special operating mode
Retraction ("Retraction after a power
interruption", page 456).
New graphic simulation ("Graphics ", page 438).
New MOD function "tool usage file" within the machine settings
group ("Tool usage file", page 469).
New MOD function "set system time" within the systems settings
group ("Set the system time", page 471).
New MOD group "graphic settings" ("Graphic settings",
page 468).
With the new cutting data calculator you can calculate the spindle
speed and the feed rate ("Cutting data calculator", page 132).
New if/then decisions were introduced in the jump commands
("Programming if-then decisions", page 255).
The character set of the fixed cycle 225 Engraving was expanded
by more characters and the diameter sign (see User's Manual for
Cycle Programming).
New fixed cycle 275 trochoidal milling (see User’s Manual for Cycle
Programming)
New fixed cycle 233 ENGRAVING (see User’s Manual for Cycle
Programming)
In the drilling cycles 200, 203 and 205 the parameter Q395 BEZUG
DEPTH REFERENCE was introduced in order to evaluate the T
ANGLE (see User's Manual for Cycle Programming).
The probing cycle 4 MEASURING IN 3-D was introduced (see
User's Manual for Cycle Programming).