beautypg.com

Speed of the setting test runs, See "speed of the setting test, Graphics 15.1 – HEIDENHAIN TNC 320 (77185x-01) ISO programming User Manual

Page 439

background image

Graphics

15.1

15

TNC 320 | User's Manual for DIN/ISO Programming | 3/2014

439

Speed of the Setting test runs

The most recently set speed stays active until a

power interruption. After the control is switched on

the speed is set to FMAX.

After you have started a program, the TNC displays the following

soft keys with which you can set the simulation speed:

Functions

Soft key

Perform the test run at the same speed at which

the program will be run (programmed feed rates

are taken into account)
Increase the simulation speed incrementally

Decrease the simulation speed incrementally

Test run at the maximum possible speed (default

setting)

You can also set the simulation speed before you start a program:

Select the function for setting the simulation

speed

Select the desired function by soft key, e.g.

incrementally increasing the simulation speed