beautypg.com

HEIDENHAIN TNC 320 (77185x-01) ISO programming User Manual

Page 34

background image

Contents

34

TNC 320 | User's Manual for DIN/ISO Programming | 3/2014

13 Manual operation and setup.......................................................................................................375

13.1 Switch-on, switch-off..........................................................................................................................376

Switch-on...............................................................................................................................................376
Switch-off...............................................................................................................................................378

13.2 Moving the machine axes..................................................................................................................379

Note.......................................................................................................................................................379
Moving the axis with the machine axis direction buttons.................................................................... 379
Incremental jog positioning...................................................................................................................379
Traverse with electronic handwheels....................................................................................................380

13.3 Spindle speed S, feed rate F and miscellaneous function M......................................................... 390

Application............................................................................................................................................. 390
Entering values......................................................................................................................................390
Adjusting spindle speed and feed rate................................................................................................. 391
Activating feed-rate limitation............................................................................................................... 391

13.4 Datum setting without a 3-D touch probe.......................................................................................392

Note.......................................................................................................................................................392
Preparation.............................................................................................................................................392
Workpiece presetting with axis keys.................................................................................................... 392
Datum management with the preset table.......................................................................................... 393

13.5 Using 3-D touch probes..................................................................................................................... 399

Overview............................................................................................................................................... 399
Functions in touch probe cycles........................................................................................................... 400
Selecting touch probe cycles................................................................................................................402
Recording measured values from the touch-probe cycles................................................................... 403
Writing measured values from the touch probe cycles in a datum table............................................. 404
Writing measured values from the touch probe cycles in the preset table.......................................... 405

13.6 Calibrating a 3-D touch trigger probe...............................................................................................406

Introduction........................................................................................................................................... 406
Calibrating the effective length............................................................................................................. 407
Calibrating the effective radius and compensating center misalignment............................................. 408
Displaying calibration values................................................................................................................. 410