HEIDENHAIN ND 930 - Manual (Page 31)

31
Error Messages
Message Problem
AMPL. X TOO LOW The encoder signal is too weak.
The scale may be contaminated.
INPUT ERROR The entered value is not within
the permissible input range.
ERROR: REF. X The spacing of the reference
marks as defined in P43 is not
the same as the actual spacing.
FRQ. EXCEEDED X The input frequency for this
encoder input is too high. This
can occur when the scale is
moved too fast.
COMP. DELETED Compensation values for non-
linear axis error compensation
erased.
PARAM. ERASED Check the operating parameters.
If this error recurs, contact your
service agency.
PGM ERASED The program has been deleted.
If this error recurs, contact your
service agency.
PGM TOO LARGE The maximum program length is
99 blocks.
Message Problem
OFFSET DELETED Offset compensation values for
encoder signals erased.
PRESET ERASED The datum points have been
erased. If this error recurs,
contact your service agency.
KEY W/O FUNCTION This key currently has no
function.
TEMP. EXCEEDED The temperature of the ND is too
high.
To clear error messages
When you have removed the cause of the error,
➤ press the CL key.
Error Messages