HEIDENHAIN ND 930 - Manual (Page 21)

21
SPEC
FCT
1
ENT
X
OVERSIZE X ?
Select the axis (for example X), enter the
oversize (for example 1 mm), confirm with ENT.
End the function.
SPEC
FCT
ENT
To enter an oversize
Select Special Functions.
SET TOOL ?
Select the Oversize function.
OVERSIZE ?
Confirm selection.
OVERSIZE ON
If required, activate Oversize.
Press the arrow down key.
Turning with Oversizes
• If the Oversize function is active, this will be indicated by a
message in the message field when you activate the
distance-to-go mode.
• Use the CL key to go back one level in the special functions.