HEIDENHAIN ND 930 - Manual (Page 20)

20
SPEC
FCT
SPEC
FCT
ENT
Turning with Oversizes
Your ND display unit can automatically take oversizes into account in
the distance-to-go mode when the Oversize function is activated. Each
axis can have a different oversize.
To active the oversize function
Select Special Functions.
SET TOOL ?
Select the Oversize function.
OVERSIZE ?
Confirm selection.
OVERSIZE OFF
Switch oversize on or off. The message field
then displays OVERSIZE ON or OVERSIZE OFF.
End the function.
Remember: oversizes are correctly compensated only for
movement toward the contour.
Turning with Oversizes
Z
X
ENT