HEIDENHAIN ND 930 - Manual (Page 18)

18
ENT
ENT
5 1 X
0 2 Z
Z
1
X
15
2
3
20 0
5
Moving the Axes with the Distance-To-Go Display
Normally, the display shows the actual position of the tool. However, it
is often more helpful to display the remaining distance to the nominal
position (the distance-to-go). You can then position simply by moving
the axis until the display value is zero.
You can enter the absolute or the relative (incremental) coordinates in
the distance-to-go display.
Example: Finish-turning a shoulder
Select the distance-to-go function.
The
∆
symbol lights up.
NOML. VALUE X =
Select the axis (e.g., X), enter the nominal
coordinate (e.g., 15 mm) (radius), confirm entry.
Move the X axis until the display value is zero.
The tool is at position 1 .
NOML. VALUE X =
Select the axis (e.g., Z), enter the nominal
coordinate (e.g., –20 mm), and confirm entry.
•
•
Moving the Axes with Distance-To-Go