HEIDENHAIN TNC 122 Technical Manual - Manual (Page 65)

64
TNC 122 12 PLC Description 4/97
Word addresses
Word Function
D288 to
D296 Actual values in the X, Y and Z axes
D300 to
D308 Nominal values in the X, Y and Z axes
D312 to
D320 Reference values in the X, Y and Z axes
D324 to
D332 Servo lag in the X, Y and Z axes
D360 Current feed rate in mm/min
D364 Maximum feed rate in mm/min
D768 to
D804 Values from MP4210.0 to MP4210.9 (deceleration signal)
W969 to
W968 Values from MP4310.0 to MP4310.4
W766 % factor for feed rate override