HEIDENHAIN TNC 122 Technical Manual - Manual (Page 27)

26
TNC 122 9 Machine Integration 4/97
MP1050 Analog voltage for rapid traverse
Input range: 4.5 to 11.0 [V]
MP1050.0 Axis X
MP1050.1 Axis Y
MP1050.2 Axis Z
MP1051 Lower limit of analog voltage
Input range:
0 to 35 [transformer increment]
(1 transformer increment = 2.93 mV)
MP1051.0 Axis X
MP1052.1 Axis Y
MP1053.2 Axis Z
MP70 Bipolar or unipolar analog voltage
Input: 0 or 2
0 = bipolar
1 = unipolar, traversing the position outputs 0 volt
2 = unipolar, traversing the position inverts the voltage
MP80 Supply voltage for position controller during rapid traverse
Input range: 0 to 2
0 = Reserved
1 = Controller input supplied with external voltage (MP1850)
2 = Controller input supplied with analog voltage from the control
MP1060 Acceleration during position approach
Input range: 0.001 to 3.0 [m/s
2 ]
MP1060.0 Axis X
MP1060.1 Axis Y
MP1060.2 Axis Z
Deceleration during position approach
Input range: 0.001 to 3.0 [m/s
2 ]
MP1060.3 Axis X
MP1060.4 Axis Y
MP1060.5 Axis Z
MP1810 k
v
factor
Input range: 0.10 to 10.00 [
m/min
mm
]
MP1810.0 Axis 1
MP1810.1 Axis 2
MP1810.2 Axis 3