HEIDENHAIN TNC 122 Technical Manual - Manual (Page 42)

4/97
TNC 122 11 Machine Parameters 41
Machine
Parameter Function and input Input value
MP4110 Time for timers T0 to T15
Input values: 0 to 65 535 [24 ms]
MP4110.0 Waiting time controller enable X
MP4110.1 Waiting time unclamp X start
MP4110.2 Waiting time clamp X stop
MP4110.3 Waiting time controller enable Y
MP4110.4 Waiting time unclamp Y start
MP4110.5 Waiting time clamp Y stop
MP4110.6 Waiting time controller enable Z
MP4110.7 Waiting time unclamp Z start
MP4110.8 Waiting time clamp Z stop
MP4110.9 SE pulse formation / duration
MP4110.10 Waiting time O5 traverse
direction, delay erosion start M36
MP4110.11 Delay time for rapid traverse
output O4 (night erosion switch-
off)
MP4110.12
MP4110.13
MP4110.14
MP4110.15
MP4120.0
to
MP4120.7 Preset value for counters C0 to C7
Input values: 0 to 65 535
MP4210 Setting a number in the PLC word range
D768 to D804
Input values: –9 999.999 to +9 999.999 [mm]
MP4210.0 X switch-off point for rapid trav.
MP4210.1 Y switch-off point for rapid trav.
MP4210.2 Z switch-off point for rapid trav.
MP4210.3 Position control loop to XYZ potentiometer=0,
NC stop, lag<0.5 Only with MP 4310.4 and .5 =1
MP4210.4 Number of D/A converter steps per PLC cycle
with control by PLC Input approx. 0.4
MP4210.5 Multiplication factor for the feed rate
potentiometer
Potentiometer value * MP4210.5= NC % block Input approx. 0.1 to 1.2
External pot. 100%: factor 0.66
External pot. 150%: factor 1.0
MP4210.6
MP4210.7 Selection of code no. for software level for
position control loop via PLC Input 1 to 8 (for software level of
TNC 121, see Chapter 10)
MP4210.8
MP4210.9