Grass Valley SCRIPT Viewer News Rev.A - Manual (Page 20)

TM
Page 18 Installation and Operations Manual • © 1999 ParkerVision, Inc.
Adjusting the Flat-Panel Display’s Image
At this point, the SCRIPTedit software should be loaded and in view on the 15” monitor. The SCRIPTview software should be
loaded on each flat-panel display. The following information enables you to adjust the image that appears on the flat-panel display.
Each display should be adjusted as needed.
Display Switches
The image switches on the 12” display are located just below the mounting bracket.
This switch controls the contrast of the display. Usually the highest contrast is
most desirable.
This switch selects the direction for the other four switches.
This switch is used to position the image horizontally within the bezel of the
monitor.
This switch is used to position the image vertically within the bezel of the
monitor.
This switch is used to provide horizontal frequency adjustment in the image,
and controls the image width.
Brightness
The brightness of the display can be set to one of two positions. The switch at the lower-left
corner of the housing allows the brightness to be shifted between either high brightness or
low brightness modes. Remember that the tilt of the monitor will have an effect on the
contrast.
Cleaning
The display can be cleaned with general-purpose window cleaner and a soft cloth. Spray the
cloth instead of the display when applying the cleaner. DO NOT use industrial solvents.
Brightness Switch