Grass Valley K2 Storage System Instruction Manual v.3.2 Nov.18 2008 - Manual (Page 370)

370 K2 Storage System Instruction Manual July 15, 2008
Chapter 8 Installing the Nearline 10 Storage System
Configuring the nearline 10 storage system
Work through the topics in this section sequentially to do the initial configuration of
the nearline 10 storage system.
• “Prerequisites for initial configuration” on page 370
• “Defining a new K2 Storage System” on page 371
• “Configuring the NH server - Part 1” on page 373
• “Configuring RAID” on page 376
• “Creating a new file system” on page 380
• “Configuring the NH server - Part 2” on page 381
• “Configuring the second NH server for NL10R” on page 382
Prerequisites for initial configuration
Before beginning your initial configuration, make sure the devices of the K2 Storage
System meet the following prerequisites. Refer to sections earlier in this manual for
detailed information. Also refer to
Chapter 9, “Description of K2 Storage Devices” .
Devices Prerequisite for nearline 10 configuration
Control point PC Ethernet cable connected
Control Point software installed
Control network IP address assigned
Network communication over the control network with all other K2
devices
Power on
Ethernet switch Ethernet cables connected
Control network IP address assigned
Power on