Grass Valley K2 Storage System Instruction Manual v.3.2 Nov.18 2008 - Manual (Page 360)

360 K2 Storage System Instruction Manual July 15, 2008
Chapter 8 Installing the Nearline 10 Storage System
• Assign a control network IP address to GigE port 1. Use standard Windows
procedures. Refer to “Networking tips” on page 112 .
• Change the hostname. Use standard Windows procedures.
• Configure SNMP properties so the trap destination points to the NetCentral server
PC. Use standard Windows procedures. If you are not using the SNMP community
name “public”, configure the community name and set permissions to RW. Also
make sure that the Authentication trap is enabled.
• For the NL10R system, install MPIO software on the NH1 K2 Media Server. Refer
to “Installing Multi-Path I/O Software on NL10R K2 Media Servers” on page 361
Also refer to “K2 Media Server descriptions” on page 397 .
Setting up the NH1-10GE K2 Media Server for Nearline
If your system has one or two NH1-10GE K2 Media Servers, prepare each server
using this section.
The Dell PowerEdge 1950 is qualified as the platform for the NH1-10GE K2 Media
Server.
Do the following to prepare a NH1-10GE K2 Media Server:
• Install the server in its permanent location. Refer to the rack mount instructions that
you received with the server’s product bundle.
• Provide power to the server.
• Connect cables as follows:
One NH1-10GE K2 Media Server on a NL10 system
Two NH1-10GE K2 Media Servers on a NL10R system
1 2
Gb 2 Gb 1
To control port
on GigE switch FTP: To 10 Gig port
on GigE switch Fibre Channel
to RAID controller
1
Gb 2 Gb 1
Fibre Channel to
RAID controller 1 Fibre Channel to
RAID controller 0 To control port
on GigE switch A
1
Gb 2 Gb 1
Fibre Channel to
RAID controller 1 Fibre Channel to
RAID controller 0 To control port
on GigE switch B
A
B
FTP: To 10 Gig port
on GigE switch A
FTP: To 10 Gig port
on GigE switch B