Grass Valley iTX Master Control v.2.3 - Manual (Page 26)

iTX-MC User Guide 2-16
iTX-MC system configuration
The text or label on the Mixer Mapper button identifies the Imagestore channel that is
currently selected on the iMC panel. It can also identify the current state of the connection
between the iMC panel’s currently selected channel and the Mixer Mapper:
Red No communication with the iMC panel.
Indicates that the Mixer Mapper component is active, but the iTX Desktop
and the iMC panel are not in synch, or that the selected channel cannot be
controlled from iTX Desktop or the iMC panel. Also, the Automation Assist
buttons on the iMC panel are not active.
The iMC panel’s channel name on its own indicates that the iMC panel is
reporting that it is connected to the same channel as the channel selected in
the iTX Desktop.
When a different channel is selected on the iMC panel, if the channel is
configured for panel control, the Mixer Mapper’s button updates to display
the new channel’s name.
NO PANEL Indicates that communication with the iMC panel has not been established.
To remedy, ensure that the Hard Panel Controller is properly configured and
that all physical connections are correct and properly fitted.
Panel
Disconnected Indicates that the iMC panel is reporting that it has no channel selected.
OUT OF SYNCH Indicates that the iMC panel is reporting that it is connected to a channel that
is not the same channel as selected in the iTX Desktop.
Not Controllable Indicates that the iMC panel is reporting that it is connected to the same
channel as selected in the iTX Desktop, but the Mixer Mapper component is
inactive or that the channel is not enabled/selected for panel control.
Slave Indicates the iMC panel is reporting that it is connected to the same channel
as selected in the iTX Desktop; the Mixer Mapper component is active and
that channel is enabled/selected for panel control, but the channel has Slave
duty for a Main/Backup iTX channel. Channel control in iTX is available only
for the Master duty, hence the Automation Assist buttons in the iTX Desktop
and on the iMC panel are not enabled for the selected channel.