Grass Valley Digital Wireless Triax Camera System - Manual (Page 4)

4 User’s Guide - Digital Wireless System version 9
Safety Summary
This informaton is intended as a guide for trained and
qualified personnel who are aware of the dangers involved
in handling potentially hazardous electrical/electronic
equipment. It is not intended to contain a complete list of all
safety precautions which should be observed by personnel in
using this or other electronic equipment.
The installation, maintenance and service of this equipment
involves risks both to personnel and equipment and must be
performed only by qualified personnel exercising due care.
Personnel engaged in the installation, operation, maintenance
or servicing of this equipment are urged to become familiar
with First Aid theory and practises.
During installation and operation of this equipment, local
building safety and fire protection standards must be observed.
Before connecting the equipment to the power supply of the
installation, the proper functioning of the protective earth
lead of the installation needs to be verified.
Whenever it is likely that safe operation is impaired, the
apparatus must be made inoperative and secured against any
unintended operation. The appropriate servicing authority
must then be informed. For example, safety is likely to be
impaired if the apparatus fails to perform the intended
function or shows visible damage.
This product has been designed and tested according to
EN60950.
ATTENTION
The radio frequency channels used by this equipment may be
constrained or restricted by law in the country where you are
operating this equipment. Check before using this equipment
that all applicable licenses or authorizations have been
obtained.
Any modifications shall void the warrantee and could make
the user liable for any disturbances caused by the modified
equipment.
Cautions and Warnings
When performing service, be sure to read and comply with the
warning and caution notices appearing in the manuals.
Warnings indicate danger that requires correct procedures or
practices to prevent death or injury to personnel. Cautions
indicate procedures or practices that should be followed to
prevent damage or destruction to equipment or property.
WARNINGS
D O NOT MODIFY THIS EQUIPMENT .
D O NOT USE THIS EQUIPMENT IN AREAS WHERE IT MAY ENDANGER
SAFETY SUCH AS HOSPITALS OR AIRPORTS
.
T HIS EQUIPMENT GENERATES ELECTROMAGNETIC RADIO FREQUENCIES .
I NSTALLATION MUST CONFROM TO THE INSTRUCTIONS GIVEN IN THIS
MANUAL .
READ THIS INFORMATION CAREFULLY BEFORE INSTALLING OR SERVICING THIS EQUIPMENT
I NSTALLATION OF THIS EQUIPMENT MUST ONLY BE PERFORMED BY
QUALIFIED PERSONNEL .
D O NOT USE ANY ACCESSORIES OTHER THAN THOSE RECOMMENDED BY
THE MANUFACTURER
.
T HE CURRENT AND VOLTAGES PRESENT IN THIS EQUIPMENT ARE
DANGEROUS . P ERSONNEL MUST AT ALL TIMES FOLLOW THE SAFETY
REGULATIONS .
A
LWAYS DISCONNECT POWER BEFORE REMOVING COVERS OR PANELS
.
A LWAYS DISCHARGE HIGH VOLTAGE POINTS BEFORE SERVICING .
N EVER MAKE INTERNAL ADJUSTMENTS , PERFORM MAINTENANCE OR
SERVICE WHEN ALONE OR WHEN FATIGUED .
I
N CASE OF AN EMERGENCY ENSURE THAT THE POWER IS
DISCONNECTED .
M OUNT EQUIPMENT SO THAT POWER LEAD CAN BE ACCESSED TO
DISCONNECT POWER .
T
HE POWER LEAD OF THE
WCU
MUST ALWAYS BE CONNECTED TO A
POWER SOCKET WITH A PROTECTIVE EARTH .
A NY INTERRUPTION OF THE PROTECTION CONDUCTOR INSIDE OR
OUTSIDE THE APPARATUS , OR DISCONNECTION OF THE PROTECTIVE
EARTH TERMINAL
,
IS LIKELY TO MAKE THE APPARATUS DANGEROUS
.
I NTENTIONAL INTERRUPTION IS PROHIBITED .
U SE ONLY FUSES OF THE TYPE AND RATING SPECIFIED .
U
SE ONLY THE ANTENNAS SUPPLIED
. D
O NOT USE THE CAMERA
WITHOUT ANTENNAS . S WITCH OFF POWER TO THE UNITS BEFORE
DETACHING ANTENNAS .
CAUTIONS
To prevent risk of overheating, ventilate the
product correctly.
Connect the product only to a power source with
the specified voltage rating.
Never connect an analog triax system to a digital
triax system.
Do not allow system ground currents to exceed
1.5A in the outer shield of the triax cable or 0.2A
in other cable shields.
Do not short circuit the inner and outer shields of
the triax cable.
Always switch off the camera before changing the
battery or changing the power supply.
Any cables connected to the camera must be less
than 3m to avoid interference.
!
!
!
!
!
!
!