Grass Valley Digital Wireless Triax Camera System - Manual (Page 31)

version 9 User’s Guide - Digital Wireless System 31
AMU Connectors (cont.)
(1) Triax connector
Triax connector
This socket is used to connect the triax cable (maximum 400m of
8mm triax cable) to the triax input of the WCU.
Receptacle types: Fischer, Tri-lock, ARD, Lemo 4, Lemo BBC,
Lemo 3.
(2) Data emitter connector (DATA)
9-pin sub-D connector
This socket is used to connect the AMU to the data emitter unit
of the antenna assembly.
(3) BNC RF receiver connectors (UHF IN)
BNC connectors
These sockets are used to connect the AMU to the antenna receiver
units of the antenna assembly.
Always use 75 Ohm cables. Phantom power of +9 V is always
switchedON.
(4) BNC RF receiver connectors (UHF OUT)
BNC connectors
These sockets are for measurement purposes only. Use short 75
Ohm cables only for measuring equipment.