Grass Valley Digital Wireless Triax Camera System - Manual (Page 23)

version 9 User’s Guide - Digital Wireless System 23
HORIZONTAL PHASE
Use COARSE and FINE adjustment for encoded video signal.
CAMERA
ON
Normally and permanently ON, this light indicates that
the WCU is powered. This indicator flashes to indicate
excessive consumption at the WCU.
OFF
This indicator lights when the AMU is not drawing
power. This indicator flashes to indicate that the AMU
consumption is excessively low (<26 W).
CABLE OPEN
This normally OFF indicator lights if there is no Digital
Triax Rack in the WCU.
ON AIR
When ON, this light indicates that the camera signal is on air
(ON AIR1).
MAINS
The equipment master on/off switch:
«I»: The equipment is operating.
«O»: The equipment is not operating.
13
14
15
16
Setting up the WCU
TRIAX 1 OK
CAM LOCK
ON
ON AIR
MAINS
I
0
OFF
CABLE
OPEN
EXT REF
SC
SC/H
FRONT
PORCH
CCU
POWER GENLOCK
VIDEO
TRIAX 2 OK
PC OK
TRIAX 1
SELECTED
TRIAX 2 SELECTED
VIDEO CHANNEL
VIDEO PARAMS
DATA CHANNEL
CAMERA
DATA
BOARD TRIAX
FREEZE
FREE RUN
COARSE
FINE
AUDIO
I/COM
RS-232 connector
Data Board
Video channel
Data channel
Rotary/push button
Camera number / menu display
WCU connections
1. Connect the triax cable from the AMU to the Triax
input 1 of the WCU. (If you use a second AMU, connect
it to Triax input 2 of the WCU.)
2. Connect the OCP to the C2IP network.
3. Connect the SDI outputs of the WCU to the studio
system.
4. If required provide a reference signal (H/V) to the
Genlock input of the WCU.
5. Connect the WCU to the mains power.
After you have made the connections to the WCU, you can set
up the following items:
• Video frequency
• Data frequency
• Camera number (set in the WCU menu)
• Signalling (set in the WCU menu)
Set the video frequency channel
• Turn the VIDEO CHANNEL rotary switch on the front of
the WCU to the same number that you set for the video
transmission frequency in the WCA.
Set the data frequency channel
• Turn the DATA CHANNEL rotary switch on the front of
the WCU to the same number that you set for the data
transmission frequency in the WCA.
Set the camera number
• Refer to the description of how to select a WCU menu
setting to set the camera number to the same number
you selected in the camera menu.
WCU Controls..