Grass Valley Digital Wireless Triax Camera System - Manual (Page 11)

version 9 User’s Guide - Digital Wireless System 11
Setting up the camera adapter (cont.)
!
Exchanging the RF Data Module
In some situations you may choose to use a different frequency
for the data channel. To use a different frequency, you need
to exchange the RF Data Module inside the camera wireless
adapter. You may also need to change the frequency module
selection switch in the AMU as well as the Data Emitter. Refer
to the section“Setting up the AMU”.
Caution
Exchange of the RF Data Module must only be
performed by qualified personnel.
Choose the RF Data Module for the frequency you want to
use:
LDK 4456/10
Camera RF Data Module 433 MHz
LDK 4456/20 Camera RF Data Module 456 MHz
To install the module you need to exchange RF Data Module
entire right side cover of the wireless camera adapter as
follows:
1. Unscrew the five screws securing the left side cover of
the adapter and carefully open. Handle the flatcable at
the bottom very carefully.
2. Locate the RF Data Module Board (third one from the
left) and disconnect the coaxial cable from the board.
3. Pull out the board gently.
4. Insert the new board and push until it firmly locks into
its socket.
5. Attach the coaxial cable to the board.
5. Replace the cover on the adapter and secure it with the
five screws.
• Attach the adapter to the camera.
• Attach the antennas to the adapter.
• Power the camera via the adapter.
• Select the video frequency via the camera menu.
• Select the data frequency via the camera menu.
• Select the camera number via the camera menu.
RF Data Module Board
Coaxial cable