Grass Valley ADVC-1000 - Manual (Page 18)

Basic Instructions Basic Instructions Basic Instructions Basic Instructions Basic Instructions
10 10 10 10 10
Basic InstructionsBasic InstructionsBasic InstructionsBasic InstructionsBasic Instructions
4. DV input time code (Lower right on the screen)
32kHz/4ch > both
REC 00:00:03;22
00:00:03:22 .......... For PAL/NTSC NDF (Non Drop Frame)
* A colon is used between seconds and frames
as a delimiter.
00:00:03;22 .......... For NTSC DF (Drop Frame)
*A semicolon is used between seconds and
frames as a delimiter.
--:--:--:-- ................ No DV signal input
Main Screen 2
This screen shows information on the current settings.
1. Analog monitor audio output (Upper side on the screen)
Monitor out:1+3/2+4
TC source:DVITC NTSC
1/2 ......................... Outputs CH1/CH2.
3/4 ......................... Outputs CH3/CH4.
1+3/2+4 ............... Outputs MIX of CH1 and CH3, MIX of CH2
and CH4.
1+2+3+4 ............. Outputs MIX of CH1, CH2, CH3 and CH4.
2. Time code input (Lower middle on the screen)
Monitor out:1+3/2+4
TC source:DVITC NTSC
DVITC .................... DVITC signal in SDI video input signal is
acquired, and converted into time code
in output DV signal.
When deck control by remote connector is enabled
Acquires VITC through the remote con-
nector to use for time code. If VITC can-
not be acquired, DVITC in SDI video in-
put signal is used.
Info
Free-run time code is used
during built-in color bar output
or when a valid time code is not
in the DV signal.