Grass Valley Adder II - Manual (Page 21)

17
Adder II
User Guide
Analog TX Modules
Adder II Analog TX modules are 16 inputs wide as shown in Figure 2-13 .
Fig. 2-13: Analog TX Module and Analog TX LED indications
• AUD: blinks Green with audio presence
• CLIP: glows Red when audio levels are clipping
• SEL: glows Blue to show that the channel is selected for adjustment
Each input accepts a mono audio signal on a male XLR. Input levels can be mic or line level
and gains as well as phantom mic power can be set from the bottom base unit.
Input parameters can be set for individual channels or entire modules/banks.
Analog RX Modules
The analog RX modules feature 16 XLR-M outputs. The module faceplate is shown in
Figure 2-14 .
Fig. 2-14: Analog RX Module and Analog RX LED indications
Each output has 3 associated LEDs as shown in Figure 2-14 .
• AUD: blinks Green with audio presence
• CLIP: glows Red when audio levels are clipping
• SEL: glows Blue to show that the channel is selected for adjustment
Each output provides a mono audio signal on a male XLR. Levels can be set at either side of
the link.