Grass Valley Adder II - Manual (Page 12)

8
Setting Up an Adder II System
Installing and Configuring the Adder II System
Installing and Configuring the Adder II System
To install and configure the Adder II system, follow these steps
1 Connect the power cables (see Power Requirements on page 9).
2 Connect the fiber and coaxial cables (see Connections on page 10).
3 Configure the data transport protocols (see Data Transport on page 13).
4 Configure the audio levels (see +18/+24 Audio Level Reference Settings on page 14).
5 Configure the Signal Generator (see Analog TR Modules on page 16).
6 Configure the Analog TR, TX, and RX modules (see Analog TX and RX Modules on
page 16).
7 Configure the Gain Control and Analog audio modules (see Local and Remote Gain
Control of Analog Audio Modules on page 18).
8 Configure the AES 8 TX and RX modules (see AES 8 TX and RX Modules on page 20).
9 Connect the Intercom modules (see Intercom Modules on page 21).
10 Interface with Legacy systems (see Legacy Systems on page 26).
11 Wire the Intercom cables (see IntercomCable Wiring on page 28).